Fishing with the neighbors







































































































































































































































Comments

Post a Comment

Popular posts from this blog

2001 Mainship 30 Pilot, Steps to operate

Image
/ Steps to operate 2001 Mainship 30 1. Open seacock for the main engine and watch for water flow after starting. Pull the black ball to open the seacock on the strainer for mains. Shut down immediately if no water flows out telltale. 2. Open the main fuel valve on Port topside of the tank for main engine fuel flow to yellow switch valve, open black valve, and close the two primer valves to run main. Genset fuel cut is on the Starboard topside of tank with a separate filter system. Fuel system allows the operator to select the filter and prime without stopping if offshore 3. In-cabin, Remove steps, turn on bilge light and switch open valves for seacocks to feed seawater to Air Conditioner and Generator. Do not open "Flush Valves" to run AC or Genny.  Seacocks for AC and Genny are shown open. Close after use! Light switch on galley panel. 4. If the head is to be used open seacock for the head, Macerator seacock is closed! Breaker for electric head an...
Read more

Brickhill River Anchorage @ Cumberland Island

Image
We fired up the The Office and proceeded to motor to Cumberland. The weather promised to be nice for the next few days. We were fortunate to enjoy a nice ride down at 1400 rpm @ 7.5 kts to Cumberland Island. Our anchorage is 9.5 miles down the ICW from Jekyll Harbor Marina (  http://www.jekyllharbor.com/  ) on Jekyll Island where we have a home slip. Location chart view   http://cruisersnet.net/cruisersnet-marine-map/?ll=31.0463,-81.4225&z=14&highlight=1 We turned off the ICW at Brickhill River and went past the primitive campsite avoiding the sand bar we anchored in 11 ft of water at mid high tide. There was one sailboat a mile away. A few fishermen visited while we were there, otherwise we were  alone. Click here for a chart view of the anchorage  http://cruisersnet.net/cruisersnet-marine-map/?ll=30.8865166667,-81.4621&z=14&highlight=1 We towed the dinghy, our 11 ft Boston Whaler, she rode easy in our wake with no problems. ...
Read more

Needed a few parts for the Cummins Engine in the Mainship

Image
Needed a few parts for my 30 Mainship. The engine is a 4TBA3.9M Cummins. I had worked on Yanmars and even taught Yanmars as an instructor. I started Diesel service in the Marines on Hercules Diesels.  I was buying parts online and saw that Cummins had a dealer Network so I located the local Cummins parts dealer (I always try to develop a sustainable local resource for my parts) and looked at the website and couldn't find any way to get a parts price other than phoning so assuming and that's my mistake for trusting and assuming the parts prices would be the same across the board if they were anything like  Yanmar or Yamaha, their dealer Network that I had accounts with before when I was an active technician. Cummins dealers online kept coming up with a Seaboard dealer ( https://www.sbmar.com/product-category/maintenance/aftercooler-heat-exchanger-maintenance-kits/ )  in California and they had some interesting videos and a lot of information. I asked...
Read more